MAC-based Access Control Commands
Extreme Networks EAS 100-24t Switch CLI Manual
279
Each command is listed, in detail, in the following sections:
Example usage:
To enable the MAC-based access control globally on the switch:
show
mac_based_access_control_local
{[mac<macaddr> | vlan<vlan_name 32> | vlanid <vlanid 1-4094>]}
show mac_based_access_control
auth_mac
{ports <portlist>}
config
mac_based_access_control
max_users
[no_limit | <value 1-128>]
enable authorization network
disable authorization network
show authorization
enable mac_based_access_control
Purpose Used to enable MAC-based access control.
Syntax enable mac_based_access_control
Description This command enables MAC-based access control on the switch. By default
this is not enabled.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
# enable mac_based_access_control
Command: enable mac_based_access_control
Success.
#
disable mac_based_access_control
Purpose Used to disable MAC-based access control.
Syntax disable mac_based_access_control
Description This will disable MAC-based access control on the switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Command Parameters
To Next Page
Loading...
