Extreme Networks EAS 100-24t Switch CLI - Show Iproute

Chapter 6: Layer 3 Features
Extreme Networks EAS 100-24t Switch CLI Manual
206
Example usage:
To delete the default IP route 10.53.13.254:
Example usage:
To display the contents of the IP routing table:
Syntax delete iproute [default]
Description This command is used to delete an existing default entry from the switch’s IP
routing table.
Parameters default – Specifies that the default IP route will be deleted.
Restrictions Only Administrator-level users can issue this command.
#delete iproute default
Command: delete iproute default
Success.
#
show iproute
Purpose Used to display the switch’s current IP routing table.
Syntax show iproute {<network_address>} {static}
Description This command is used to display the switch’s current IP routing table.
Parameters <network_address> - The network IP address.
static – Select a static IP route.
Restrictions None.
#show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway Interface Hops Protocol
--------------- ---------- ----------- ---- -----------
0.0.0.0 10.1.1.254 System 1 Default
10.0.0.0/8 10.48.74.122 System 1 Local
Total Entries: 2
#
delete iproute