Extreme Networks EAS 100-24t Switch CLI User Manual

Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
184
Example usage:
To enable Q-in-Q:
Example usage:
To disable Q-in-Q:
Description This command is used to enable Q-in-Q mode.
When Q-in-Q is enabled, all network port roles will be NNI port and their outer
TPID will be set to 88a8. All existing static VLANs will run as SP-VLAN. All
dynamically learned L2 address will be cleared. GVRP and STP need to be
disabled manually.
If you need to run GVRP on the switch, firstly enable GVRP manually. The
default setting of Q-in-Q is disabled
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable qinq
Command: enable qinq
Success.
#
disable qinq
Purpose This command is used to disable Q-in-Q mode.
Syntax disable qinq
Description This command is used to disable Q-in-Q mode.
All dynamically learned L2 address will be cleared. All dynamically registered
VLAN entries will be cleared, GVRP will be disabled.
If you need to run GVRP on the switch, firstly enable GVRP manually. All
existing SP-VLANs will run as static 1Q VLANs. The default setting of Q-in-Q
is disabled.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#disable qinq
Command: disable qinq
Success.
#
enable qinq

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English