Extreme Networks EAS 100-24t Switch CLI Manual
5
CHAPTER
1
Introduction
The Extreme Networks EAS 100-24t Switch CLI Manual contains information for the setup and
management of the switch. This manual is intended for network managers familiar with network
management concepts and terminology. This manual provides a reference for all of the commands
contained in the CLI.
The switch can be managed through the switch’s serial port, Telnet, or the Web-based management
agent. The command-line interface (CLI) can be used to configure and manage the switch via the serial
port or Telnet interfaces.
Accessing the Switch via the Serial Port
The switch’s serial port’s default settings are as follows:
● 9600 baud
● no parity
● 8 data bits
● 1 stop bit
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial
port configured as above are then connected to the switch’s serial port via an RS-232 DB-9 cable.
With the serial port properly connected to a management computer, the following screen should be
visible. If this screen does not appear, try pressing Ctrl+R to refresh the console screen.
Figure 1: Initial CLI screen
Press any key to login...
EAS 100-24t Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.002
Copyright (C) 2000-2011 Extreme Networks.
All rights reserved.
UserName:admin
PassWord:
EAS 100-24t:admin#
To Next Page
Loading...
Need help?
General
