Extreme Networks EAS 100-24t Switch CLI - Config Radius Delete

802.1X Commands
Extreme Networks EAS 100-24t Switch CLI Manual
245
Example usage:
To configure the RADIUS server communication settings:
Example usage:
To delete previously configured RADIUS server communication settings:
Parameters <server_index 1-3> - Assigns a number to the current set of RADIUS server
settings. Up to three groups of RADIUS server settings can be entered on the
switch.
<server_ip> - The IP address of the RADIUS server.
key - Specifies that a password and encryption key will be used between the
switch and the RADIUS server.
<passwd 32> - The shared-secret key used by the RADIUS server and the
switch. Up to 32 characters can be used.
default - Uses the default UDP port number in both the “auth_port” and
“acct_port” settings.
auth_port <udp_port_number 1-65535> - The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> - The UDP port number for accounting
requests. The default is 1813.
Restrictions Only Administrator-level users can issue this command.
#config radius add 1 10.48.74.121 key exn default
Command: config radius add 1 10.48.74.121 key exn default
Success.
#
config radius delete
Purpose Used to delete a previously entered RADIUS server configuration.
Syntax config radius delete <server_index 1-3>
Description This command is used to delete a previously entered RADIUS server
configuration.
Parameters <server_index 1-3> - Assigns a number to the current set of RADIUS server
settings. Up to three groups of RADIUS server settings can be entered on the
switch.
Restrictions Only Administrator-level users can issue this command.
#config radius delete 1
Command: config radius delete 1
Success.
#
config radius add