Extreme Networks EAS 100-24t Switch CLI User Manual

Chapter 4: Management
Extreme Networks EAS 100-24t Switch CLI Manual
118
Example usage:
To configure time zone settings:
Restrictions Only Administrator-level users can issue this command.
#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
#
config dst
Purpose Used to enable and configure time adjustments to allow for the use of Daylight
Savings Time (DST).
Syntax [disable | repeating {s_week <start_week 1-5,last> | s_day <start_day
sun-sat> | s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_week
<end_week 1-5,last> | e_day <end_day sun-sat> | e_mth <end_mth 1-12>
| e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} (9) | annual
{s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time
<end_time hh:mm> | offset [30 | 60 | 90 | 120]} (7)]
Description DST can be enabled and configured using this command. When enabled this
will adjust the system clock to comply with any DST requirement. DST
adjustment effects system time for both manually configured time and time set
using SNTP service.
Parameters disable - Disable the DST seasonal time adjustment for the switch.
repeating - Using repeating mode will enable DST seasonal time adjustment.
Repeating mode requires that the DST beginning and ending date be
specified using a formula. For example, specify to begin DST on Saturday
during the second week of April and end DST on Sunday during the last week
of October.
annual - Using annual mode will enable DST seasonal time adjustment.
Annual mode requires that the DST beginning and ending date be specified
concisely. For example, specify to begin DST on April 3 and end DST on
October 14.
s_week - Configure the week of the month in which DST begins.
<start_week 1-5,last> - The number of the week during the month in which
DST begins where 1 is the first week, 2 is the second week and so on, last is
the last week of the month.
e_week - Configure the week of the month in which DST ends.
<end_week 1-5,last> - The number of the week during the month in which
DST ends where 1 is the first week, 2 is the second week and so on, last is
the last week of the month.
s_day – Configure the day of the week in which DST begins.
<start_day sun-sat> - The day of the week in which DST begins expressed
using a three character abbreviation (sun, mon, tue, wed, thu, fri, sat)
config time_zone

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English