Extreme Networks EAS 100-24t Switch CLI - Config Cos Mapping Ports

QoS Commands
Extreme Networks EAS 100-24t Switch CLI Manual
221
Example usage:
To display the current 802.1p default priority configuration on the switch:
# show 802.1p default_priority
Command: show 802.1p default_priority
Port Priority
---- --------
1 0
2 0
3 0
4 0
5 0
6 0
7 0
8 0
9 0
10 0
11 0
12 0
13 0
14 0
15 0
16 0
17 0
18 0
19 0
20 0
21 0
22 0
23 0
24 0
#
config cos mapping ports
Purpose Used to configure the CoS to port mapping method to be used on the switch.
Syntax config cos mapping ports [<portlist> | all] [none | {ethernet [802.1p] | ip
[tos | dscp]}]
Description This command is used to set the method of which incoming packets will be
identified for the CoS to port mapping feature on the switch. Identified packets
will be forwarded to the appropriate CoS queue.
Parameters <portlist> - Specifies a port or range of ports to be configured.
all – Specifies all ports will be configured.
none - Disable all priority-base CoS features.
ethernet - Enable Ethernet frame based priority.
802.1p - Enable 802.1p CoS
ip - Enable IP frame based priority.
tos – Here the user can enable ToS
dscp – Here the user can enable DSCP.