Extreme Networks EAS 100-24t Switch CLI User Manual

Chapter 9: Security
Extreme Networks EAS 100-24t Switch CLI Manual
268
Example usage:
To display the login and enable method list for all applications on the switch:
#show authen application
Command: show authen application
Application Login Method List Enable Method List
------------- ------------------ ---------------------
Console default default
Telnet Zira default
SSH default default
HTTP default default
#
create authen server_host
Purpose Used to create an authentication server host.
Syntax create authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ |
radius] {port <int 1-65535> | key [<key_string 254> | none] | timeout <int
1-255> | retransmit <int 1-255>}
Description This command is used to create an authentication server host for the
TACACS/XTACACS/TACACS+/RADIUS security protocols on the switch.
When a user attempts to access the switch with authentication protocol
enabled, the switch will send authentication packets to a remote TACACS/
XTACACS/TACACS+/RADIUS server host on a remote host. The TACACS/
XTACACS/TACACS+/RADIUS server host will then verify or deny the request
and return the appropriate message to the switch. More than one
authentication protocol can be run on the same physical server host but,
remember that TACACS/XTACACS/TACACS+/RADIUS are separate entities
and are not compatible with each other. The maximum supported number of
server hosts is 16.

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English