Extreme Networks EAS 100-24t Switch CLI - Disable Web; Enable Web

Basic Switch Commands
Extreme Networks EAS 100-24t Switch CLI Manual
25
Example usage:
To connect to a device through telnet with an IP address of 10.53.13.99:
Example usage:
To enable HTTP and configure port number:
Parameters <ipaddr> - Enter the IP address of the device to connect through, using
Telnet.
tcp_port <value 0-65535> - Enter the TCP port number used to connect
through. The common TCP port number for telnet is 23.
Restrictions Only Administrator-level users can issue this command.
#telnet 10.53.13.99 tcp_port 23
Command: telnet 10.53.13.99 tcp_port 23
enable web
Purpose Used to enable the HTTP-based management software on the switch.
Syntax enable web {<tcp_port_number 1-65535>}
Description This command is used to enable the Web-based management software on the
switch. The user can specify the TCP port number the switch will use to listen
for Telnet requests.
Parameters <tcp_port_number 1-65535> - The TCP port number. TCP ports are numbered
between 1 and 65535. The “well-known” port for the Web-based management
software is 80.
Restrictions Only Administrator-level users can issue this command.
#enable web 80
Command: enable web 80
Note: SSL will be disabled if web is enabled.
Success.
#
disable web
Purpose Used to disable the HTTP-based management software on the switch.
Syntax disable web
Description This command disables the Web-based management software on the switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
telnet