Extreme Networks EAS 100-24t Switch CLI User Manual

Traffic Segmentation Commands
Extreme Networks EAS 100-24t Switch CLI Manual
189
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
Example usage:
To display the current traffic segmentation configuration on the switch:
#config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
#
show traffic_segmentation
Purpose Used to display the current traffic segmentation configuration on the switch.
Syntax show traffic_segmentation {<portlist>}
Description This command is used to display the current traffic segmentation configuration
on the switch.
Parameters <portlist> - Specifies a port or range of ports for which the current traffic
segmentation configuration on the switch will be displayed.
Restrictions The port lists for segmentation and the forward list must be on the same
switch.
#show traffic_segmentation
Command: show traffic_segmentation
Traffic Segmentation Table
Port Forward Portlist
---- --------------------------------------------------
1 1-24
2 1-24
3 1-24
4 1-24
5 1-24
6 1-24
7 1-24
8 1-24
9 1-24
10 1-24
11 1-24
12 1-24
13 1-24
14 1-24
15 1-24
16 1-24
17 1-24
18 1-24
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English