Extreme Networks EAS 100-24t Switch CLI - Download

Chapter 3: Fundamentals
Extreme Networks EAS 100-24t Switch CLI Manual
32
Example usage:
To download a configuration file:
Syntax download [firmware_fromTFTP [<ipaddr> | <ipv6addr>] <path_filename
64> image_id <value 1-2> | cfg_fromTFTP [<ipaddr> | <ipv6addr>]
<path_filename 64> {increment}]
Description This command is used to download a new firmware or a switch configuration
file from a TFTP server.
Parameters firmware_fromTFTP - Download and install new firmware on the switch from a
TFTP server.
cfg_fromTFTP - Download a switch configuration file from a TFTP server.
<ipaddr> - The IP address of the TFTP server.
<ipv6addr> - The IPv6 address of the TFTP server.
<path_filename> - The DOS path and filename of the firmware or switch
configuration file on the TFTP server. For example, C:\ EAS10024T.had.
image_id <value 1-2> - Specify the working section ID. The switch can hold
two firmware versions for the user to select from, which are specified by
section ID.
increment - Allows the download of a partial switch configuration file. This
allows a file to be downloaded that will change only the switch parameters
explicitly stated in the configuration file. All other switch parameters will remain
unchanged.
Restrictions The TFTP server must be on the same IP subnet as the switch. Only
Administrator-level users can issue this command.
#download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
Success.
#
#-------------------------------------------------------------------
# EAS 100-24t Configuration
#
# Firmware: Build 1.00.002
# Copyright (C) 2000-2011 Extreme Networks. All rights reserved.
#-------------------------------------------------------------------
# BASIC
config serial_port baud_rate 115200 auto_logout never
config terminal_line default
download