Extreme Networks EAS 100-24t Switch CLI - Show Qinq; Show Qinq Ports

Q-in-Q Commands
Extreme Networks EAS 100-24t Switch CLI Manual
185
Example usage:
To show global Q-in-Q status:
Example usage:
To show the Q-in-Q status for ports 1 to 4:
show qinq
Purpose Used to show global Q-in-Q
Syntax show qinq
Description This command is used to show the global Q-in-Q status.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#show qinq
Command: show qinq
QinQ Status: Enabled
#
show qinq ports
Purpose Used to show global Q-in-Q and port Q-in-Q mode status.
Syntax show qinq ports {<portlist>}
Description This command is used to show the global Q-in-Q status, including:
port role in Q-in-Q mode and port outer TPID.
Parameters <portlist> - Specifies a range of ports to be displayed.
If no parameter is specified, the system will display all Q-in-Q port information.
Restrictions Only Administrator-level users can issue this command.
#show qinq ports 1-4
Command: show qinq ports 1-4
Port Role Outer TPID VLAN Translation
---- ---- ---------- ----------------
1 NNI 0x88a8 Disabled
2 NNI 0x88a8 Disabled
3 NNI 0x88a8 Disabled
4 NNI 0x88a8 Disabled
Total Entries : 4
#