Extreme Networks EAS 100-24t Switch CLI - Disable Snmp Authenticate_Traps; Enable Snmp Authenticate_Traps

Network Management (SNMP) Commands
Extreme Networks EAS 100-24t Switch CLI Manual
83
Example Usage:
To display the list of trust hosts:
Example usage:
To enable SNMP authentication trap support:
#show trusted_host
Command: show trusted_host
Management Stations
IP Address/Netmask
-----------------------
10.53.13.94/32
Total Entries: 1
#
enable snmp authenticate_traps
Purpose This command is used to enable SNMP authentication trap support.
Syntax enable snmp authenticate_traps
Description This command is used to enable SNMP authentication trap support.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable snmp authenticate_traps
Command: enable snmp authenticate_traps
Success.
#
disable snmp authenticate_traps
Purpose This command is used to disable SNMP authentication trap support.
Syntax disable snmp authenticate_traps
Description This command is used to disable SNMP authentication trap support.
Parameters None.
Restrictions Only Administrator-level users can issue this command.