Chapter 4: Management
Extreme Networks EAS 100-24t Switch CLI Manual
66
Example usage:
To modify the banner:
Restrictions Only Administrator-level users can issue this command. Other restrictions
include:
If the “reset” command is executed, the modified banner will remain modified.
However, the “reset config/reset system” command will reset the modified
banner to the original factory banner.
The capacity of the banner is 6*80. 6 Lines and 80 characters per line.
Ctrl+W will only save the modified banner in the DRAM. Users need to type
the “save config/save all” command to save it into Flash.
Only valid in threshold level.
#config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
EAS 100-24t Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.002
Copyright (C) 2000-2011 Extreme Networks All rights reserved.
================================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
-------------------------------------------------------------------------------
show greeting_message
Purpose Used to view the currently configured greeting message configured on the
switch.
Syntax show greeting_message
Description This command is used to view the currently configured greeting message on
the switch.
Parameters None.
Restrictions None.
config greeting_message
To Next Page
Loading...
