Extreme Networks EAS 100-24t Switch CLI User Manual

Switch Port Commands
Extreme Networks EAS 100-24t Switch CLI Manual
111
Parameters all - Configure all ports on the switch.
<portlist> - Specifies a port or range of ports to be configured.
medium_type [fiber | copper] – The command is available for the user to
enable or disable the port with the specified medium type. When one medium
type specified is enabled, the other medium type is disabled implicitly. That is,
each of the two types of the transport medium shall be enabled exclusively.
Both of the medium types of a specified port can be disabled at the same
time. The Copper port is selected (enabled) by default.
speed – Allows the user to adjust the speed for a port or range of ports. The
user has a choice of the following:
auto - Enables auto-negotiation for the specified range of ports.
[10 | 100 | 1000] - Configures the speed in Mbps for the specified range of
ports. Gigabit ports are statically set to 1000 but can be set to slower speeds.
[half | full] - Configures the specified range of ports as either full-duplex or
half-duplex.
[master | slave] - The master setting (1000M/Full_M) will allow the port to
advertise capabilities related to duplex, speed and physical layer type. The
master setting will also determine the master and slave relationship between
the two connected physical layers. This relationship is necessary for
establishing the timing control between the two physical layers. The timing
control is set on a master physical layer by a local source. The slave setting
(1000M/Full_S) uses loop timing, where the timing comes from a data stream
received from the master. If one connection is set for 1000M/Full_M, the other
side of the connection must be set for 1000M/Full_S. Any other configuration
will result in a link down status for both ports.
flow_control [enable | disable] – Enable or disable flow control for the specified
ports.
state [enable | disable] - Enables or disables the specified range of ports.
learning [enable | disable] - Enables or disables the MAC address learning on
the specified range of ports.
description <desc 32> - Enter an alphanumeric string of no more than 32
characters to describe a selected port interface.
clear_description - Enter this command to clear the port description of the
selected port(s).
mdix – Specifies the MDIX setting of the port. The MDIX setting can be auto,
normal or cross.
If set to normal state, the port in MDIX mode, can be connected to PC NIC
using a straight cable. If set to cross state, the port in mdi mode, can be
connected to a port (in mdix mode) on another switch through a straight cable.
Restrictions Only Administrator-level users can issue this command.
config ports

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English