Extreme Networks EAS 100-24t Switch CLI User Manual

SSH Commands
Extreme Networks EAS 100-24t Switch CLI Manual
293
Example usage:
To view the current authentication mode set on the switch:
Usage example:
To configure the SSH server:
Restrictions None.
#show ssh authmode
Command: show ssh authmode
The SSH Authmode:
-------------------------------------------------
Password : Enabled
Publickey : Enabled
Hostbased : Enabled
#
config ssh server
Purpose Used to configure the SSH server.
Syntax config ssh server {maxsession <int 1-8> | contimeout <sec 120-600> |
authfail <int 2-20> | rekey [10min | 30min | 60min | never]}
Description This command is used to configure the SSH server.
Parameters maxsession <int 1-8> - Allows the user to set the number of users that may
simultaneously access the switch. The default setting is 8.
contimeout <sec 120-600> - Allows the user to set the connection timeout.
The user may set a time between 120 and 600 seconds. The default is 120
seconds.
authfail <int 2-20> - Allows the administrator to set the maximum number of
attempts that a user may try to logon utilizing SSH authentication. After the
maximum number of attempts is exceeded, the switch will be disconnected
and the user must reconnect to the switch to attempt another login.
rekey [10min | 30min | 60min | never] - Sets the time period that the switch
will change the security shell encryptions.
Restrictions Only Administrator-level users can issue this command.
#config ssh server maxsession 2 contimeout 300 authfail 2
Command: config ssh server maxsession 2 contimeout 300 authfail 2
Success.
#
show ssh authmode

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English