Extreme Networks EAS 100-24t Switch CLI User Manual

Network Management (SNMP) Commands
Extreme Networks EAS 100-24t Switch CLI Manual
79
Example usage:
To create an SNMP host to receive SNMP messages:
Description This command is used to create a recipient of SNMP traps generated by the
switch’s SNMP agent.
Parameters <ipaddr> – The IP address of the remote management station that will serve
as the SNMP host for the switch.
v1 – Specifies that SNMP version 1 will be used. The Simple Network
Management Protocol (SNMP), version 1, is a network management protocol
that provides a means to monitor and control network devices.
v2c – Specifies that SNMP version 2c will be used. The SNMP v2c supports
both centralized and distributed network management strategies. It includes
improvements in the Structure of Management Information (SMI) and adds
some security features.
v3 – Specifies that the SNMP version 3 will be used. SNMP v3 provides
secure access to devices through a combination of authentication and
encrypting packets over the network. SNMP v3 adds:
Message integrity - ensures that packets have not been tampered with during
transit.
Authentication - determines if an SNMP message is from a valid source.
Encryption - scrambles the contents of messages to prevent it being viewed
by an unauthorized source.
noauth_nopriv – Specifies that there will be no authorization and no encryption
of packets sent between the switch and a remote SNMP manager.
auth_nopriv – Specifies that authorization will be required, but there will be no
encryption of packets sent between the switch and a remote SNMP manager.
auth_priv – Specifies that authorization will be required, and that packets sent
between the switch and a remote SNMP manger will be encrypted.
<auth_string 32> – An alphanumeric string used to authorize a remote
SNMP manager to access the switch’s SNMP agent.
Restrictions Only Administrator-level users can issue this command.
#create snmp host 10.48.74.100 v3 auth_priv public
Command: create snmp host 10.48.74.100 v3 auth_priv public
Success.
#
delete snmp
Purpose Used to remove a recipient of SNMP traps generated by the switch’s SNMP
agent.
Syntax delete snmp [host <ipaddr>]
Description This command is used to delete a recipient of SNMP traps generated by the
switch’s SNMP agent.
Parameters <ipaddr> – The IP address of a remote SNMP manager that will receive
SNMP traps generated by the switch’s SNMP agent.
create snmp

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English