Extreme Networks EAS 100-24t Switch CLI - CTRL+C ESC Q Quit SPACE N Next Page ENTER Next Entry a All; Show Serial_Port

Basic Switch Commands
Extreme Networks EAS 100-24t Switch CLI Manual
21
Example usage:
To display the switch’s information:
#show switch
Command: show switch
Device Type : EAS 100-24t Gigabit Ethernet Switch
MAC Address : 00-40-66-49-E9-91
IP Address : 0.0.0.0 (Manual)
VLAN Name : default
Subnet Mask : 0.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 1.00.002
Firmware Version : Build 1.00.001
Hardware Version : A
Serial Number : 170892110008
System Name :
System Location :
System Uptime : 0 days, 1 hours, 1 minutes, 2 seconds
System Contact :
Spanning Tree : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
802.1X : Disabled
Telnet : Enabled (TCP 23)
Web : Enabled (TCP 80)
RMON : Disabled
SSH : Disabled
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
show serial_port
Purpose Used to display the current serial port settings.
Syntax show serial_port
Description This command is used to display the current serial port settings.
Parameters None.
Restrictions None