Extreme Networks EAS 100-24t Switch CLI - Network Monitoring Commands

Network Monitoring Commands
Extreme Networks EAS 100-24t Switch CLI Manual
89
Example Usage:
To disable RMON:
Network Monitoring Commands
The Network Monitoring commands in the CLI are listed (along with the appropriate parameters) in the
following table:
#disable rmon
Command: disable rmon
Success.
#
Command Parameters
show packet ports <portlist>
show error ports <portlist>
show utilization cpu
show utilization dram
show utilization flash
show utilization ports {<portlist>}
clear counters {ports <portlist>}
clear log
show log {index <value_list X-Y>}
enable syslog
disable syslog
show syslog
create syslog host <index 1-4> {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number>
| ipaddress [<ipaddr>] | state [enable | disable]}
config syslog {host [all | <index 1-4>]} {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress [<ipaddr>] | state [enable | disable]}
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
delete ipif [System] [ipv6address <ipv6networkaddr>]
enable ipif_ipv6_link_local_auto [System]
disable ipif_ipv6_link_local_auto [System]
show ipif_ipv6_link_local_auto