Extreme Networks EAS 100-24t Switch CLI User Manual

Chapter 5: Layer 2 Features
Extreme Networks EAS 100-24t Switch CLI Manual
196
Example usage:
To set ingress checking status and the sending and receiving of GVRP information:
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
Parameters <portlist> - A port or range of ports for which users want to enable GVRP for.
all - Specifies all of the ports on the switch.
state [enable | disable] - Enables or disables GVRP for the ports specified in
the port list.
ingress_checking [enable | disable] - Enables or disables ingress checking for
the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states the frame
type that will be accepted by the switch for this function. tagged_only implies
that only VLAN tagged frames will be accepted, while admit_all implies tagged
and untagged frames will be accepted by the switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with the port.
Restrictions Only Administrator-level users can issue this command.
#config gvrp 1-4 state enable ingress_checking enable acceptable_frame tagged_only
pvid 2
Command: config gvrp 1-4 state enable ingress_checking enable acceptable_frame
tagged_only pvid 2
Success.
#
enable gvrp
Purpose Used to enable GVRP on the switch.
Syntax enable gvrp
Description This command, along with disable gvrp below, is used to enable and disable
GVRP on the switch, without changing the GVRP configuration on the switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable gvrp
Command: enable gvrp
Success.
#
config gvrp

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English