Extreme Networks EAS 100-24t Switch CLI - Show Dot1 V_Protocol_Group

Protocol VLAN Commands
Extreme Networks EAS 100-24t Switch CLI Manual
181
Example usage:
To delete protocol group 1:
Example usage:
To display the protocol group ID 1:
Syntax delete dot1v_protocol_group [group_id <int 1-16> | group_name <name
32> | all]
Description This command is used to delete a protocol group.
Parameters group_id – Specifies the group ID to be deleted.
group_name – The name of the protocol group.
all – All groups
Restrictions Only Administrator-level users can issue this command.
# delete dot1v_protocol_group group_id 1
Command: delete dot1v_protocol_group group_id 1
Success.
#
show dot1v_protocol_group
Purpose Used to display the protocols defined in a protocol group.
Syntax show dot1v_protocol_group {[group_id <int 1-16> | group_name <name
32>]}
Description This command is used to display the protocols defined in protocol groups.
Parameters group_id – Specifies the group ID to be displayed. If a group ID is not
specified, all configured protocol groups will be displayed.
group_name – The name of the protocol group.
Restrictions None.
# show dot1v_protocol_group group_id 1
Command: show dot1v_protocol_group group_id 1
Protocol Group ID Protocol Group Name Frame Type Protocol Value
----------------- -------------------------------- -------------- --------------
1 General_Group EthernetII 86dd
1 General_Group IEEE802.3 SNAP 86dd
Total Entries: 1
#
delete dot1v_protocol_group