Extreme Networks EAS 100-24t Switch CLI - Show Auth_Diagnostics

802.1X Commands
Extreme Networks EAS 100-24t Switch CLI Manual
249
Example usage:
To view the current RADIUS authentication client:
#show auth_client
radiusAuthClient ==>
radiusAuthClientInvalidServerAddresses 0
radiusAuthClientIdentifier Extreme
radiusAuthServerEntry ==>
radiusAuthServerIndex :1
radiusAuthServerAddress 0.0.0.0
radiusAuthClientServerPortNumber 0
radiusAuthClientRoundTripTime 0
radiusAuthClientAccessRequests 0
radiusAuthClientAccessRetransmissions 0
radiusAuthClientAccessAccepts 0
radiusAuthClientAccessRejects 0
radiusAuthClientAccessChallenges 0
radiusAuthClientMalformedAccessResponses 0
radiusAuthClientBadAuthenticators 0
radiusAuthClientPendingRequests 0
radiusAuthClientTimeouts 0
radiusAuthClientUnknownTypes 0
radiusAuthClientPacketsDropped 0
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
show auth_diagnostics
Purpose Used to display the current authentication diagnostics.
Syntax show auth_diagnostics {ports <portlist>}
Description This command is used to display the current authentication diagnostics of the
switch on a per port basis.
Parameters ports <portlist> - Specifies a range of ports.
Restrictions None.