Extreme Networks EAS 100-24t Switch CLI - Q-In-Q Commands; Enable Qinq

Q-in-Q Commands
Extreme Networks EAS 100-24t Switch CLI Manual
183
Example usage:
To display protocol VLAN information for ports 1 to 2:
Q-in-Q Commands
The Q-in-Q commands in the CLI are listed (along with the appropriate parameters) in the following
table:
Each command is listed, in detail, in the following sections:
# show port dot1v ports 1-2
Command: show port dot1v ports 1-2
Port: 1
Protocol Group ID VLAN Name Protocol Priority
------------------- --------------------------------- -----------------
3 default -
4 VLAN300 -
5 marketing-1 -
Port: 2
Protocol Group ID VLAN Name Protocol Priority
------------------- --------------------------------- -----------------
3 default -
4 VLAN300 -
5 marketing-1 -
Total Entries: 6
#
Command Parameters
enable qinq
disable qinq
show qinq
show qinq ports {<portlist>}
config qinq ports [<portlist> | all] {role [uni | nni] | outer_tpid <hex 0x1-0xffff> | vlan_translation
[enable | disable]}
create vlan_translation [add cvid <vidlist> svid <vlanid 1-4094> | replace cvid <vlanid 1-4094> svid
<vlanid 1-4094>]
delete vlan_translation cvid [<vidlist> | all]
show vlan_translation cvid {<vidlist>}
enable qinq
Purpose This command is used to enable the Q-in-Q mode.
Syntax enable qinq