Extreme Networks EAS 100-24t Switch CLI User Manual

SSH Commands
Extreme Networks EAS 100-24t Switch CLI Manual
291
The Secure Shell (SSH) commands in the CLI are listed (along with the appropriate parameters) in the
following table.
Each command is listed, in detail, in the following sections.
Usage example:
To enable SSH:
Command
Parameters
enable ssh
disable ssh
config ssh authmode [password | publickey | hostbased] [enable | disable]
show ssh authmode
config ssh server {maxsession <int 1-8> | contimeout <sec 120-600> | authfail <int 2-20> | rekey
[10min | 30min | 60min | never]}
show ssh server
config ssh user <username 15> authmode [hostbased [hostname <domain_name 32> |
hostname_IP <domain_name 32> <ipaddr>] | password | publickey]
show ssh user authmode
config ssh algorithm [3DES | AES128 | AES192 | AES256 | arcfour | blowfish | cast128 |
twofish128 | twofish192 | twofish256 | MD5 | SHA1 | RSA | DSA] [enable |
disable]
show ssh algorithm
enable ssh
Purpose Used to enable SSH.
Syntax enable ssh
Description This command is used to enable SSH on the switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable ssh
Command: enable ssh
Success.
#
disable ssh
Purpose Used to disable SSH.
Syntax disable ssh
Description This command is used to disable SSH on the switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English