Extreme Networks EAS 100-24t Switch CLI - Show Cos Mapping

Chapter 7: Quality of Service (QoS)
Extreme Networks EAS 100-24t Switch CLI Manual
222
Example usage:
To configure port 1 as CoS-enabled:
Restrictions Only Administrator-level users can issue this command.
#config cos mapping ports 1 ethernet 802.1p
Command: config cos mapping ports 1 ethernet 802.1p
Success.
#
show cos mapping
Purpose Used to show CoS mapping.
Syntax show cos mapping {ports [<portlist> | all]}
Description This command is used to display information regarding CoS mapping enabled
ports and their mapping method.
Parameters <portlist> - Specifies a range of ports to be displayed. If no parameter is
specified, the all ports priority settings will be shown.
all – Specifies that all the ports will be displayed.
Restrictions None.
config cos mapping ports