Extreme Networks EAS 100-24t Switch CLI - Reboot; Reset

Basic Switch Commands
Extreme Networks EAS 100-24t Switch CLI Manual
27
To save the switch’s the current configuration and log to non-volatile RAM:
Example usage:
To restart the switch:
To force the switch to restart:
#save all
Command: save all
Saving all configurations and log information to NV-RAM......
Done.
Success.
#
reboot
Purpose Used to restart the switch.
Syntax reboot {force_agree}
Description This command is used to restart the switch.
Parameters force_agree – When force_agree is specified, the switch will be forced to
restart immediately without further confirmation.
Restrictions Only Administrator-level users can issue this command.
#reboot
Command: reboot
If you do not save the settings, all changes made in this session will be lost.
Are you sure you want to proceed with the system reboot?(y/n)y
Please wait, the switch is rebooting...
#reboot force_agree
Command: reboot force_agree
Please wait, the switch is rebooting...
reset
Purpose Used to reset the switch to the factory default settings.
Syntax reset {[config | system]} {force_agree}
Description This command is used to restore the switch’s configuration to the default
settings assigned from the factory.