Extreme Networks EAS 100-24t Switch CLI User Manual

Chapter 3: Fundamentals
Extreme Networks EAS 100-24t Switch CLI Manual
28
Example usage:
To restore all of the switch’s parameters to their default values except the IP address, user accounts, and
switch logs:
To restore all of the switch’s parameters to their default values:
To restore all of the switch’s parameters to their default values and have the switch save and reboot:
Parameters config - If the keyword ‘config’ is specified, all of the factory default settings
are restored on the switch including the IP address, user accounts, and the
switch history log. The switch will not save or reboot.
system - If the keyword ‘system’ is specified all of the factory default settings
are restored on the switch. The switch will save and reboot after the settings
are changed to default. Rebooting will clear all entries in the Forwarding Data
Base.
force_agree – When force_agree is specified, the reset command will be
executed immediately without further confirmation.
If no parameter is specified, the switch’s current IP address, user accounts,
and the switch history log are not changed. All other parameters are restored
to the factory default settings. The switch will not save or reboot.
Restrictions Only Administrator-level users can issue this command.
#reset
Command: reset
Are you sure you want to proceed with system reset
except IP address, log and user account?(y/n)
Success.
#
#reset config
Command: reset config
Are you sure you want to proceed with system reset?(y/n)
Success.
#
#reset system
Command: reset system
Are you sure you want to proceed with system reset, save and reboot?(y/n)
Load Factory Default Configuration... Done.
Saving all configurations to NV-RAM.. Done.
Please wait, the switch is rebooting...
reset

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English