Extreme Networks EAS 100-24t Switch CLI User Manual

LLDP Commands
Extreme Networks EAS 100-24t Switch CLI Manual
57
Example usage
To configure the LLDP forward LLDPDU:
Example usage
To display the LLDP system level configuration status:
# config lldp forward_message enable
Command: config lldp forward_message enable
Success.
#
show lldp
Purpose This command displays the switch’s general LLDP configuration status.
Syntax show lldp
Description This command is used to display the switch’s general LLDP configuration
status.
Parameters None.
Restrictions None.
#show lldp
Command: show lldp
LLDP System Information
Chassis Id Subtype : MAC Address
Chassis Id : 00-04-96-52-83-9C
System Name :
System Description : Gigabit Ethernet Switch
System Capabilities : Repeater, Bridge
LLDP Configurations
LLDP Status : Disable
LLDP Forward Status : Disable
Message Tx Interval : 30
Message Tx Hold Multiplier: 4
ReInit Delay : 2
Tx Delay : 2
Notification Interval : 5
#
show lldp mgt_addr
Purpose Used to display the LLDP management address information.
Syntax show lldp mgt_addr {[ipv4 <ipaddr>]}
Description This command is used to display LLDP management address information.
Parameters ipv4 - IP address of IPV4.

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English