Extreme Networks EAS 100-24t Switch CLI User Manual

Time and SNTP Commands
Extreme Networks EAS 100-24t Switch CLI Manual
119
Example usage:
To configure daylight savings time on the switch:
e_day - Configure the day of the week in which DST ends.
<end_day sun-sat> - The day of the week in which DST ends expressed using
a three character abbreviation (sun, mon, tue, wed, thu, fri, sat)
s_mth - Configure the month in which DST begins.
<start_mth 1-12> - The month to begin DST expressed as a number.
e_mth - Configure the month in which DST ends.
<end_mth 1-12> - The month to end DST expressed as a number.
s_time – Configure the time of day to begin DST.
<start_time hh:mm> - Time is expressed using a 24-hour clock, in hours and
minutes.
e_time - Configure the time of day to end DST.
<end_time hh:mm> - Time is expressed using a 24-hour clock, in hours and
minutes.
s_date - Configure the specific date (day of the month) to begin DST.
<start_date 1-31> - The start date is expressed numerically.
e_date - Configure the specific date (day of the month) to end DST.
<end_date 1-31> - The end date is expressed numerically.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are 30,60,90,120. The
default value is 60
Restrictions Only Administrator-level users can issue this command.
#config dst repeating s_week 2 s_day tue s_mth 4 s_time 15:00 e_week 2 e_day wed
e_mth 10 e_time 15:30 offset 30
Command: config dst repeating s_week 2 s_day tue s_mth 4 s_time 15:00 e_week 2 e_day
wed e_mth 10 e_time 15:30 offset 30
Success.
#
show time
Purpose Used to display the current time settings and status.
Syntax show time
Description This command is used to display system time and date configuration as well
as display current system time.
Parameters None.
Restrictions None.
config dst

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English