Extreme Networks EAS 100-24t Switch CLI - Show Ssh Algorithm

Chapter 9: Security
Extreme Networks EAS 100-24t Switch CLI Manual
296
Usage example:
To configure SSH algorithm:
Description This command is used to configure the desired type of SSH algorithm used for
authentication encryption.
Parameters 3DES – This parameter will enable or disable the Triple_Data Encryption
Standard encryption algorithm.
AES128 - This parameter will enable or disable the Advanced Encryption
Standard AES128 encryption algorithm.
AES192 - This parameter will enable or disable the Advanced Encryption
Standard AES192 encryption algorithm.
AES256 - This parameter will enable or disable the Advanced Encryption
Standard AES256 encryption algorithm.
arcfour - This parameter will enable or disable the Arcfour encryption
algorithm.
blowfish - This parameter will enable or disable the Blowfish encryption
algorithm.
cast128 - This parameter will enable or disable the Cast128 encryption
algorithm.
twofish128 - This parameter will enable or disable the twofish128 encryption
algorithm.
twofish192 - This parameter will enable or disable the twofish192 encryption
algorithm.
twofish256 - This parameter will enable or disable the twofish256 encryption
algorithm.
MD5 - This parameter will enable or disable the MD5 Message Digest
encryption algorithm.
SHA1 - This parameter will enable or disable the Secure Hash Algorithm
encryption.
RSA - This parameter will enable or disable the RSA encryption algorithm.
DSA - This parameter will enable or disable the Digital Signature Algorithm
encryption.
[enable | disable] – This allows the user to enable or disable algorithms
entered in this command, on the switch.
Restrictions Only Administrator-level users can issue this command.
# config ssh algorithm blowfish enable
Command: config ssh algorithm blowfish enable
Success.
#
show ssh algorithm
Purpose Used to display the SSH algorithm setting.
Syntax show ssh algorithm
config ssh algorithm