Extreme Networks EAS 100-24t Switch CLI - Clear Log; Enable Syslog; Show Log

Chapter 4: Management
Extreme Networks EAS 100-24t Switch CLI Manual
94
Example usage:
To clear the log information:
Example usage:
To display the switch history log:
clear log
Purpose Used to clear the switch’s history log.
Syntax clear log
Description This command is used to clear the switch’s history log.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#clear log
Command: clear log
Success.
#
show log
Purpose Used to display the switch history log.
Syntax show log {index <value_list X-Y>}
Description This command is used to display the contents of the switch’s history log.
Parameters index <value_list X-Y> - This command will display the history log, beginning
and ending at the value specified by the user in the <value_list X-Y> field.
If no parameter is specified, all history log entries will be displayed.
Restrictions None.
#show log index 1-5
Command: show log index 1-5
Index Data Time Log Text
----- ---------- -------- ------------------------------------------------------
3 0000-00-00 00:02:43 Successful login through Console (Username: admin)
2 0000-00-00 00:00:43 System cold start
1 0000-00-00 00:00:38 Port 1 link up, 100Mbps FULL duplex
#
enable syslog
Purpose Used to enable the system log to be sent to a remote host.
Syntax enable syslog