Extreme Networks EAS 100-24t Switch CLI - Delete Authen Server_Group; Show Authen Server_Group

Chapter 9: Security
Extreme Networks EAS 100-24t Switch CLI Manual
274
Example usage:
To add an authentication host to server group “group_1”:
Example usage:
To delete the server group “group_1”:
# config authen server_group group_1 add server_host 10.1.1.121 protocol tacacs+
Command: config authen server_group group_1 add server_host 10.1.1.121 protocol
tacacs+
Success.
#
delete authen server_group
Purpose Used to delete a user-defined authentication server group.
Syntax delete authen server_group <string 15>
Description This command is used to delete an authentication server group.
Parameters <string 15> - Enter an alphanumeric string of up to 15 characters to define the
previously created server group to be deleted.
Restrictions Only Administrator-level users can issue this command.
#delete authen server_group group_1
Command: delete authen server_group group_1
Success.
#
show authen server_group
Purpose Used to view authentication server groups on the switch.
Syntax show authen server_group {<string 15>}
Description This command is used to display authentication server groups currently
configured on the switch.
This command will display the following fields:
Group Name - The name of the server group currently configured on the
switch, including built in groups and user defined groups.
IP Address - The IP address of the server host.
Protocol - The authentication protocol used by the server host.