Extreme Networks EAS 100-24t Switch CLI - Initial Console Screen after Logging in; The? Command

Chapter 1: Introduction
Extreme Networks EAS 100-24t Switch CLI Manual
8
After the switch reboots and you have logged in, the console looks like this:
Figure 4: Initial Console Screen after logging in
Commands are entered at the command prompt, #.
There are a number of helpful features included in the CLI. Entering the ? command will display a list
of all of the top-level commands.
Figure 5: The ? Command
When users enter a command without its required parameters, the CLI will prompt users with Next
possible completions: message.
EAS 100-24t Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.002
Copyright (C) 2000-2011 Extreme Networks. All rights reserved.
UserName:admin
PassWord:
EAS 100-24t:admin#
..
?
cable_diag ports
clear
clear arptable
clear counters
clear fdb
clear log
clear mac_based_access_control auth_mac
clear port_security_entry port
config 802.1p default_priority
config 802.1p user_priority
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x capability ports
config 802.1x init
config 802.1x reauth
config access_profile profile_id
config account
config admin local_enable
config arp_aging time
config arpentry
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All