Extreme Networks EAS 100-24t Switch CLI - Layer 2 Features

Extreme Networks EAS 100-24t Switch CLI Manual
121
CHAPTER
5
Layer 2 Features
Asymmetric VLAN Commands
The Asymmetric VLAN commands in the CLI are listed (along with the appropriate parameters) in the
following table:
Each command is listed, in detail, in the following sections:
Example usage:
To enable asymmetric VLANs:
Command
Parameters
enable asymmetric_vlan
disable asymmetric_vlan
show asymmetric_vlan
enable asymmetric_vlan
Purpose Used to enable asymmetric VLANs on the switch.
Syntax enable asymmetric_vlan
Description This command is used to enable the asymmetric VLAN function on the switch
Parameters None.
Restrictions Only Administrator-level users can issue this command.
#enable asymmetric_vlan
Command: enable asymmetric_vlan
Success.
#