Extreme Networks EAS 100-24t Switch CLI - Protocol VLAN Commands; Create Dot1 V_Protocol_Group Group_Id

Protocol VLAN Commands
Extreme Networks EAS 100-24t Switch CLI Manual
179
Protocol VLAN Commands
The Protocol VLAN commands in the CLI are listed (along with the appropriate parameters) in the
following table:
Each command is listed, in detail, in the following sections:
Example usage:
To create a protocol group:
Command Parameters
create dot1v_protocol_group
group_id
<int 1-16> {group_name <name 32>}
config dot1v_protocol_group [group_id <int 1-16> | group_name <name 32>] [add protocol [ethernet_2 |
ieee802.3_snap] <hex> | delete protocol [ethernet_2 | ieee802.3_snap] <hex>]
delete dot1v_protocol_group [group_id <int 1-16> | group_name <name 32> | all]
show dot1v_protocol_group {[group_id <int 1-16> | group_name <name 32>]}
config port dot1v ports [all] [add protocol_group [group_id <int 1-16> | group_name <name 32>] [vlan
<vlan_name 32> | vlanid <int>] {priority <value 0-7>} | delete protocol_group
[group_id <int 1-16> | all]]
show port dot1v {ports <portlist>}
create dot1v_protocol_group group_id
Purpose Used to create a protocol group for the protocol VLAN function.
Syntax create dot1v_protocol_group group_id <int 1-16> {group_name <name
32>}
Description This command is used to create a protocol group for the protocol VLAN
function.
Parameters group_id - The ID of the protocol group which is used to identify a set of
protocols.
group_name - The name of the protocol group. The maximum length is 32
characters. If a group name is not specified, the group name will be
automatically generated in accordance with ProtocolGroup+group_id. For
example, the auto-generated name for group ID 2 is ProtocolGroup2. If the
auto-generated name is in conflict with an existing group, an alternative name
will be used in accordance with ProtocolGroup+group_id+ALT+num. The value
for num starts with 1. If it is still in conflict, then subsequent number will be
used instead. As an example: The auto-generated name for group ID 1 is
“ProtocolGroup1”.
If this name already exists, then ProtocolGroup1ALT1 will be used instead.
Restrictions Only Administrator-level users can issue this command.
# create dot1v_protocol_group group_id 1 group_name General_Group
Command: create dot1v_protocol_group group_id 1 group_name General_Group
Success.
#