Extreme Networks EAS 100-24t Switch CLI User Manual

Multiple Authentication Commands
Extreme Networks EAS 100-24t Switch CLI Manual
289
Example usage:
This example displays authorization status:
Multiple Authentication Commands
The Multiple Authentication commands in the CLI are listed (along with the appropriate parameters) in
the following table.
Each command is listed, in detail, in the following sections.
Usage example:
The following example sets the multiple authentication method of all ports to any:
#show authorization
Command: show authorization
Authorization : Enabled
#
Command
Parameters
config authentication auth_mode [port_based | host_based]
show authentication ports {<portlist>}
config authentication auth_mode
Purpose This command is used to configure the authentication mode of security port(s).
Syntax config authentication auth_mode [port_based | host_based]
Description The user can use this command to configure authorization mode on ports. If
the device supports multiple authentication, the port will be operated based on
the authentication mode configured by the multiple authentication command.
Parameters auth_mode - Specifies the authentication mode used.
port_based - If one of the attached hosts passes the authentication, all hosts
on the same port will be granted to access network. If the user fails to
authorize, this port will keep trying the next authentication
host_based - Every user can be authenticated individually. Default value is
host_based.
Restrictions Only Administrator-level users can issue this command.
#config authentication auth_mode port_based
Command: config authentication auth_mode port_based
Success.
#

Extreme Networks EAS 100-24t Switch CLI Specifications

General

Brand	Extreme Networks
Model	EAS 100-24t Switch CLI
Category	Switch
Language	English