Access Authentication Control Commands
Extreme Networks EAS 100-24t Switch CLI Manual
259
Parameters default – The default method list for access authentication, as defined by the
user. The user may choose one or a combination of up to four(4) of the
following authentication methods:
tacacs – Adding this parameter will require the user to be authenticated using
the TACACS protocol from the remote TACACS server hosts of the TACACS
server group list.
xtacacs – Adding this parameter will require the user to be authenticated using
the XTACACS protocol from the remote XTACACS server hosts of the
XTACACS server group list.
tacacs+ – Adding this parameter will require the user to be authenticated
using the TACACS+ protocol from the remote TACACS+ server hosts of the
TACACS+ server group list.
radius - Adding this parameter will require the user to be authenticated using
the RADIUS protocol from the remote RADIUS server hosts of the RADIUS
server group list.
server_group <string 15> - Adding this parameter will require the user to be
authenticated using a user-defined server group previously configured on the
switch.
local - Adding this parameter will require the user to be authenticated using
the local user account database on the switch.
none – Adding this parameter will require no authentication to access the
switch.
method_list_name – Enter a previously implemented method list name defined
by the user. The user may add one, or a combination of up to four of the
following authentication methods to this method list:
tacacs – Adding this parameter will require the user to be authenticated using
the TACACS protocol from a remote TACACS server.
xtacacs – Adding this parameter will require the user to be authenticated using
the XTACACS protocol from a remote XTACACS server.
tacacs+ – Adding this parameter will require the user to be authenticated
using the TACACS+ protocol from a remote TACACS+ server.
radius - Adding this parameter will require the user to be authenticated using
the RADIUS protocol from a remote RADIUS server.
server_group <string 15> - Adding this parameter will require the user to be
authenticated using a user-defined server group previously configured on the
switch.
local - Adding this parameter will require the user to be authenticated using
the local user account
database on the switch.
none – Adding this parameter will require no authentication to access the
switch.
NOTE: Entering none or local as an authentication protocol will override any
other authentication that follows it on a method list or on the default method
list.
Restrictions Only Administrator-level users can issue this command.
config authen_login
To Next Page
Loading...
