Grandstream Networks UCM6510 User Manual

P a g e | 357
UCM6510 IP PBX User Manual
Version 1.0.20.31
My Voicemail
 Default Code: *97
 Press *97 to access the voicemail box.
Agent Pause
 Default Code: *83
 Pause the agent in all call queues.
Agent Unpause
 Default Code: *84
 Unpause the agent in all call queues.
Paging Prefix
 Default Code: *81
 To page an extension, enter the code followed by the extension
number.
Intercom Prefix
 Default Code: *80
 To intercom an extension, enter the code followed by the
extension number.
Blacklist Add
 Default Code: *40
 To add a number to blacklist for inbound route, dial *40 and
follow the voice prompt to enter the number.
Blacklist Remove
 Default Code: *41
 To remove a number from current blacklist for inbound route,
dial *41 and follow the voice prompt to remove the number.
Call Pickup on Ringing
 Default Code: **
 To pick up a call for any extension xxxx, enter the code followed
by the extension number xxxx.
Pickup In-call
 Default Code: *45 (Disabled by default).
 If “Pickup In-call” feature is enabled, only the extensions added
in “Allowed to seamless transfer” in the extension’s Seamless
Transfer Privilege Control List” can pick up the call.
Pickup Extension
 Default Code: *8
 This code is for the pickup group, which can be assigned for
each extension on the extension configuration page.
 If there is an incoming call to an extension, other extensions
within same pickup group can dial *8 directly to pick up the call.
Direct Dial Voicemail Prefix
 Default Code: *
 This code is for the user to directly dial or transfer to an
extension's voicemail.
 For example, directly dial *5000 will have to call go into the
extension 5000's voicemail. If the user would like to transfer the
call to the extension 5000's voicemail, enter *5000 as the
transfer target number.

Grandstream Networks UCM6510 Specifications

General

Brand	Grandstream Networks
Model	UCM6510
Category	PBX
Language	English