1074 HEIDENHAIN Technical Manual MANUALplus 620
The data in the HEIDENHAIN motor table and in the inverter.inv power
module table on the SYS partition is write-protected. You can open the tables,
but you cannot edit them.
If you use a motor that appears in the motor table, but only the data for the
speed encoders differs, you can overwrite this data in the motor table with
MP_motStr, MP_motDir and MP_motEncType. The motor table is not
actually changed. The changes only take place in the working memory.
MP_name
Type of power supply module
Available from NCK software version: 597 110-05.
Format: Selection menu
Selection: Name of the power supply module from the "supply.spy" power
supply module table (entered automatically by the
MANUALplus 620)
Default: –
Access: LEVEL3
Reaction: RESET
MP_motSupply
Key name of the motor's power supply module
Available from NCK software version: 597 110-05.
Format: Selection menu
Selection: Enter the key name of the power supply module that drives this
motor. All power-supply-module key names defined under
CfgSupplyModule are available for selection.
Default: –
Access: LEVEL3
Reaction: RUN
MP_ampName
Type of axis/spindle power module
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: Name of the power module from the inverter.inv power module
table (entered by the MANUALplus 620)
Default: –
Access: LEVEL3
Reaction: RESET
The power module table of older HEIDENHAIN contouring controls,
MOTOR.AMP, is no longer supported by the MANUALplus 620!
The original entry from the motor table is only used if MP_motStr,
MP_motDir and MP_motEncType are not in the configuration.
To Next Page
Loading...
