HEIDENHAIN MANUALPLUS 620 - Page 414

414 HEIDENHAIN Technical Manual MANUALplus 620
CfgPosCorrection
Parameters for asynchronous position compensation
enable
100501
(optional parameter)
Asynchronous position compensation on/off
Input:
 on:
Asynchronous position compensation is
switched on
 off:
Asynchronous position compensation is
switched off
RUN
LEVEL3
1253
feed
100502
(optional parameter)
Velocity for asynchronous position
compensation
Velocity intended for compensations.
Input: 0 to 99 960 [mm/min]
Default: 960 [mm/min]
RUN
LEVEL3
1253
CfgHandwheel
Parameters for configuring the electronic handwheel;
Configuration of serial handwheel connected to X23.
type
100601
MP7640
Type of handwheel
Enter the model of the connected handwheel. If
you set the value HRNAX, you must enter more
details on the connected handwheel in
MP_CfgAxisHandwheel.
Format: Selection menu
Input:
 NONE:
No serial handwheel connected
 HRNAX:
Up to three HR 150 handwheels via HRA 110
handwheel adapter
 HR410:
HR 410 portable handwheel
 HR332:
HR 332 portable handwheel
 HR330:
HR 330 portable handwheel
 HR130:
HR 130 panel-mounted handwheel
RUN
LEVEL3
1334
initValues
100602
MP7645
Initialization values for handwheel
Format: List [0 to 7]
Input: 0 to 255
Default: 0
RUN
LEVEL3
1334
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page