416 HEIDENHAIN Technical Manual MANUALplus 620
feedFactor
100608
Manual feed rates in the El. Handwheel mode
Percentage factor for the 3 velocity levels. The
effective handwheel feed rate is equal to the feed-
rate percentage factor multiplied by the maximum
handwheel feed rate of the selected axis.
Format: List [0 to 2]
Input:
[0] = First ratio [%]
[1] = Second ratio [%]
[2] = Third ratio [%]
Default: 1, 10 and 100 [%]
RUN
LEVEL3
1336
selectAxes
100610
(optional parameter)
Selection of axes for the handwheel
Select the axes to be moved with the handwheel.
Extra information:
On portable handwheels with axis keys,
e.g. HR 410:
Make a list entry for each axis key on the
handwheel. The sequence of the list sets the
assignment to the axis keys X, Y, Z, IV, V on the
handwheel.
With HR 150 panel-mounted handwheels
through HRA 110:
Handwheel on X1 of HRA 110: 1st list entry
Handwheel on X2 of HRA 110: 2nd list entry
Handwheel on X3 of HRA 110: The initialization
parameters and the position of the selection
switch set which list entry is to be used.
With HR 130 panel-mounted handwheel:
Do not define parameter. The axes are assigned
via the PLC program (e.g. Module 9036).
Format: List [0 to 8]
Input: Select the axes using the selection
menu
RUN
LEVEL3
1338
crossShortSafety
100609
MP7640
(optional parameter)
Cross-circuit-proof handwheel
Specifies whether a cross-circuit test is
performed on the permissive buttons.
Format: Selection menu
Input:
on: Cross-circuit test is active
off: No cross-circuit test
RUN/
LEVEL3
1337
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page
To Next Page
Loading...
