438 HEIDENHAIN Technical Manual MANUALplus 620
override100Ratio
103411
Compensation for differing adjustment of the
override potentiometers
Reserved for HEIDENHAIN, do not make any
entries in this parameters on your own.
Format: Numerical value
Input: 0.5 to 1.0
Default: 0.6275
PLC/Pgm
run is
locked
LEVEL3
–
overrideDelta
103407
(optional parameter)
Compensation for thermal noise in override
potentiometers
Format: Numerical value
Input: 0.0001 to 0.1
Default: 0.0005
PLC/Pgm
run is
locked
LEVEL3
1360
overrideIntegDelta
103408
(optional parameter)
Compensation for thermal noise in override
potentiometers
Format: Numerical value
Input: 0.0001 to 1.0
Default: 0.025
PLC/Pgm
run is
locked
LEVEL3
1360
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page
To Next Page
Loading...
