HEIDENHAIN MANUALPLUS 620 - Page 448

448 HEIDENHAIN Technical Manual MANUALplus 620
spindleMode
104006
(optional parameter)
Symbolic name or the number of a word
marker
Name or number of the word marker in which the
spindle mode of rotation (96 = constant spindle
speed, 97 = constant cutting speed) is
transmitted to the PLC. Depending on the value of
the word marker, the PLC evaluates either the
content of MP_spindleSpeed or
MP_cuttingSpeed.
No input:
The spindle mode of rotation cannot be read as a
numerical value.
Format: String
Input: PLC operand, max. 80 characters
RESET
LEVEL3
1564
gearCode
104007
(optional parameter)
Symbolic name or number of the PLC word for
the gear range
Name of the PLC word in which the gear range is
transmitted to the PLC.
No input:
No gear range is transmitted
Format: String
Input: PLC operand, max. 80 characters
RESET
LEVEL3
1569
gearSpeed0
104008
(optional parameter)
Key names of parameter sets for gear ranges
(operating mode 0)
Format: List [0 to 100]
Input: Key name of parameter sets
(operating mode 0)
RESET
LEVEL3
1569
gearSpeed1
104009
(optional parameter)
Key names of parameter sets for gear ranges
(operating mode 1)
Format: List [0 to 100]
Input: Key name of parameter sets
(operating mode 1)
RESET
LEVEL3
1569
gearStop
104010
MP3030, bit 1
(optional parameter)
Switch off the spindle when the gear range is
changed
Format: Selection menu
Input:
 TRUE:
If a strobe for changing the gear range is output,
the control automatically switches the spindle
off.
 FALSE:
If a strobe for changing the gear range is output,
the spindle is not switched off.
RESET
LEVEL3
597 110-03
1569
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page