HEIDENHAIN MANUALPLUS 620 - Page 501

January 2012 4.10 List of Machine Parameters 501
CfgNcErrorReaction
Behavior of programmable errors FN14: ERROR;
FN14 errors are triggered only if the error warning level given in the PET table is smaller than or equal
to the warning level set here. Note that errors with warning level 0 are always triggered and errors
with warning level 5 are never triggered.
warningLevel
200601
Warning level of channel
Format: Numerical value
Input: 0 to 4
0: FN14 errors with warning level = 0 are
triggered
1: FN14 errors with warning level </= 1 are
triggered
2: FN14 errors with warning level </= 2 are
triggered
3: FN14 errors with warning level </= 3 are
triggered
4: FN14 errors with warning level </= 4 are
triggered
Default: 0
RUN
LEVEL1
619
CfgNcPgmParState
Specification for storage of Q/QS parameters
Defines the persistent storage and name of the current Q/QS parameter set
persistent
200701
Persistent storage of the Q/QS parameters
Format: Selection menu
Input:
 TRUE:
Q/QS parameters are saved persistently in the
current parameter set at the end of the
program, see MP_currentSet.
 FALSE:
Q/QS parameters are not stored
Default: FALSE
RUN
LEVEL1
620
currentSet
200702
Name of the current Q/QS parameter set
If no other name is given, the key name of the
machining channel is used for saving.
Format: String
Input: Max. 18 characters
RUN
LEVEL1
620
CfgNcPgmBehaviour
Defines the behavior of the MANUALplus 620 during NC program run
operatingTimeReset
200801
Reset the machining time when program starts. RESET
LEVEL3
620
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page