HEIDENHAIN MANUALPLUS 620 - Page 514

514 HEIDENHAIN Technical Manual MANUALplus 620
axisMode
300105
MP10 (expanded)
Axis operating mode
Format: Selection menu
Input:
 NotAllowed:
Reserved, do not use!
 NotActive:
Axis does not exist
 Active:
Axis physically present
 Virtual:
Virtual axis for superimposed movements
 PlcControlled:
e.g. for encoded spindles; axis is controlled
solely by the PLC
Default: Active
RESET
LEVEL3
636
testMode
300106
Axis in test mode
Note:
Axes in Test mode must be enabled in the SIK.
Format: Selection menu
Input:
 TRUE:
Test mode for commissioning, i.e. the axis
needs not be connected
 FALSE:
Test mode not active.
If MP_axisMode = Active: Axis must be
connected electrically.
Default: FALSE
RESET
LEVEL3
636
parList
(300107)
List of all parameter sets of this axis
Multiple parameter sets can be created for an
axis. The key name is used to select the desired
set.
Example: PX (parameter set for X axis).
Format: List [0 to 10]
Input: Key name(s) from ParameterSets
RESET
LEVEL3
637
realAxis
300108
(optional parameter)
Key name of the associated real axis
For TNC contouring controls:
Parameter reserved, do not assign.
The key name of the associated real axis is only to
be entered if the current axis is a virtual axis (e.g.
for noncylindrical grinding).
Format: Selection menu
Input: Key name of axis from
Axes/PhysicalAxis
RESET
LEVEL3
637
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page