HEIDENHAIN MANUALPLUS 620 - Page 534

534 HEIDENHAIN Technical Manual MANUALplus 620
limitSpeedDec
400314
(optional parameter)
Limit speed for reduction of the braking
deceleration
Braking of the spindle with a "kink" in the
deceleration curve:
The parameter sets the absolute limit speed
above which the braking deceleration is reduced.
Format: Numerical value
Input: Value [°/min] or [mm/min]
Default: 0
Allowed in
strobe
LEVEL3
597 110-05
1013
limitAccSpeedCtrl
400315
(optional parameter)
Absolute acceleration. Effective above
MP_limitSpeedAcc
Acceleration of the spindle with a "kink" in the
acceleration curve:
Specifies the absolute acceleration of the spindle,
which becomes effective above the speed
defined with MP_limitSpeedAcc.
Format: Numerical value
Input: Value [m/s
2
]
Default: 0
Allowed in
strobe
LEVEL3
597 110-05
1013
limitDecSpeedCtrl
400316
(optional parameter)
Absolute deceleration during braking.
Effective above MP_limitSpeedDec
Braking of the spindle with a "kink" in the
deceleration curve:
Specifies the absolute deceleration during
braking, which becomes effective above the
speed defined with MP_limitSpeedDec.
Format: Numerical value
Input: Value [m/s
2
]
Default: 0
Allowed in
strobe
LEVEL3
597 110-05
1013
M19MaxSpeed
MP3520.1
Maximum rotational speed limit for M19
Format: Numerical value
Input: 100 to 20 000 [rpm]
Default: 1 000 [rpm]
Allowed in
strobe
LEVEL3
1003
M19NcSpeed
400310
Nominal speed for an oriented spindle stop
commanded by the NC
Format: Numerical value
Input: Shaft speed [rpm]
Default: 8
Allowed in
strobe
LEVEL3
597 110-03
1003
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page