January 2012 4.10 List of Machine Parameters 535
nominalSpeed
400308
(optional parameter)
Rated speed for the gear range
Enter the greatest programmable shaft speed at
which this spindle parameter set is to be used. If
a shaft speed greater than the given one is
programmed, the next higher gear range is
switched to.
Format: Numerical value
Input: Shaft speed [rpm]
Default: 0
Allowed in
strobe
LEVEL3
1570
restoreFeed
400309
(optional parameter)
Feed rate for returning to the contour
Format: Numerical value
Input: Feed rate [mm/min] or [°/min]
Default: 0
Allowed in
strobe
LEVEL3
597 110-02
623
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page
To Next Page
Loading...
