HEIDENHAIN MANUALPLUS 620 - Page 589

January 2012 4.10 List of Machine Parameters 589
ToolMount
[Key names of the tool holders]
CfgToolMount
Description of the tool holder
mountPosWAPP
600401
(W)APP designation of holder location
Enter the number of this tool holder according to
the WAPP principle:
W = Tool carrier number (1 to 6)
A = Holder position (0 to 3)
PP = Swivel position of the turret
Format: Numerical value
Input: 1 to 6999
Value as a whole number (integer)
RESET
LEVEL3
1400
freeTnr
600402
Free T number of the tool holder
Enter a unique T number for each tool holder. The
value 0 is reserved by the control, and represents a
tool whose geometric dimensions are 0.
Format: Numerical value
Input: 1 to 899
Value as a whole number (integer)
RESET
LEVEL3
1401
distCarrierRefX
600407
Distance to carrier reference point in X
Enter the distance between the tool holder
reference point and the tool carrier reference point
in [mm].
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
RESET
LEVEL3
1401
distCarrierRefZ
600408
Distance to carrier reference point in Z
Enter the distance between the tool holder
reference point and the tool carrier reference point
in [mm].
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
RESET
LEVEL3
1401
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page