HEIDENHAIN MANUALPLUS 620 - Page 590

590 HEIDENHAIN Technical Manual MANUALplus 620
distCarrierRefY
600409
Distance to carrier reference point in Y
Enter the distance between the tool holder
reference point and the tool carrier reference point
in [mm].
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
RESET
LEVEL3
1402
correctionX
600410
Compensation in X of the tool-holder position
Enter an X compensation value for the tool holder
position that the control adds to the value from
MP_distCarrierRefX.
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
RESET
LEVEL3
1402
correctionZ
600411
Compensation in Z of the tool-holder position
Enter a Z compensation value for the tool holder
position that the control adds to the value from
MP_distCarrierRefZ.
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
RESET
LEVEL3
1402
correctionY
600412
Compensation in Y of the tool-holder position
Enter a Y compensation value for the tool holder
position that the control adds to the value from
MP_distCarrierRefY.
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
RESET
LEVEL3
1402
coorTrafoToModify
600414
Coordinate transformations to be modified (up
to NC software 548 328-02)
Enter the key names of the coordinate
transformations that are to be replaced by the
transformations in coorTrafo at the same position
during axis mirroring.
Format: List [0 to 100]
Input: Selection menu
Coordinate transformations off
CfgTrafoByDir
RESET
LEVEL3
761
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page