HEIDENHAIN MANUALPLUS 620 - Page 591

January 2012 4.10 List of Machine Parameters 591
coorTrafo
600415
Modified coordinate transformations (up to NC
software 548 328-02)
Enter the key names of the coordinate
transformations that are to replace the
transformations in coorTrafoToModify at the
same position during axis mirroring.
Format: List [0 to 100]
Input: Selection menu
Coordinate transformations off
CfgTrafoByDir
RESET
LEVEL3
761
kinModelToModify
600418
Subkinematics to be replaced
Enter the key names of the subkinematics that are
to be replaced by the subkinematics in kinModel at
the same position during axis mirroring.
Format: List [0 to 100]
Input: Selection menu
Coordinate transformations off
CfgKinSimpleModel
RESET
LEVEL3
746
kinModel
600419
Subkinematics to be activated
Enter the key names of the subkinematics that are
to replace the subkinematics in
kinModelToModify at the same position during
axis mirroring.
Format: List [0 to 100]
Input: Selection menu
Coordinate transformations off
CfgKinSimpleModel
RESET
LEVEL3
746
mirroringAxes
600416
Axes to be mirrored
Enter the key names of the axes that are to be
mirrored for this tool holder.
Format: List [0 to 100]
Input: Selection menu
Key names from
Axes/PhysicalAxis
RESET
LEVEL3
1403
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page